4
Listening to the Radio
1. Push the “POWER” button (1) once to turn the unit on.
2. Press the “BAND” button (12) to select a radio
band: FM1, FM2, FM3, AM1 or AM2.
3. To manually tune in a radio station, rotate the
“Tuning” knob (3) right or left until the desired
station is located.
4. To “Automatic Scan” to the next strong station.
Press and release the “Tuning” knob (3). The
tuner will scan up and wait for 5 seconds then
scan up again. Once the desired station is found,
press the knob again to stop the scan function.
5. To “Seek” up or down to the next station, momen-
tarily
rotate the “Tuning” knob (3) right or left
and hold it for more than one second then
release it.
Programming the Unit
You can program up to 15 FM radio stations and 10 AM radio stations.
1. Select FM1, FM2, FM3, AM1 or AM2 by pressing the “BAND” button (12) repeatedly while watching the
indication on the display (16).
2. Use the “Tuning” or “Scan” (3) knob to select the desired station.
3. Press and hold one of the five station recall buttons (4-8). The button number and “CH” appears in the
display area (16). Release the button.
4. Repeat the procedure to memorize more stations as desired.
Sound Controls
Volume Button:
Press the “VOLUME” button (2) to select between
the sound controls Volume, Bass, Treble, Balance
and Fader (Figures A-E).
Bass Control:
The bass control adjusts the amount of low
frequency that you hear.
Treble Control:
The treble control adjusts the amount of high
frequency that you hear.
Balance Control:
The balance control adjusts the amount of sound
output to the left and right speakers.
Fader Control:
The fader control adjusts the amount of sound
output to the front and rear speakers.
☛
Figure A
Figure B
Figure C
Figure D
Figure E
9900CD Manual 1/20/03 12:19 PM Page 4