Filter
Top Products
4
Interface module
This attention to detail also applies to the RS232 module. There is
no electrical connection between the RS232 ports and the internal
circuitry. This prevents any noise from the external controlling
system entering the audio circuitry.
We hope that this information explains a bit more about this
unconventional control amplifier, but if you would like to know
more about this or any of our products please contact us. Enjoy
your music!
Special features of the KOLEKTOR
In addition to providing all the features you would expect on a
high-quality preamplifier, the KOLEKTOR also provides several
unique features.
Bass and treble controls
The Linn KOLEKTOR includes subtle bass and treble controls.
These provide slight frequency response adjustments to allow you
to enhance the sound from small loudspeakers, or adjust the sound
when the system is being used in a small room.
Independent source settings
The Linn KOLEKTOR can remember the volume, balance, bass, and
treble settings for each of the sources. This allows you to
compensate for any tonal differences between your sources,
without having to readjust the settings each time you switch
sources.
25
Number Name Description Values
U7 RC5 Amplifier Configures the amplifier address. 0 = 16
Address Leave at 16 for KOLEKTOR handset. 1 = 19
U8 Enable Unity Gain Enables an input as a unity gain input. 0 = Disabled
For use with an external surround sound 1 = Input 1
processor. 2 = Input 2
3 = Input 3
4 = Input 4
5 = Input 5
6 = Input 6
7 = Input 7
8 = Input 8
9 = Input 9
10 = Input 10
U9 Default Display Defines the display after the time-out 0 = Maintain
period specified by U10. After a further 1 = Volume
time-out period U2 defines the display. 2 = Balance
3 = Bass
4 = Treble
5 = Source name
6 = Source number
7 = Source name/number
U10 Time-Out Period Specifies the display time-out period, used 0 = 2 seconds
by U9. 1 = 5 seconds
2 = 10 seconds
3 = 15 seconds
4 = 20 seconds
U11 Volume Control Defines how volume and balance change on 0 = Fade volume/balance
MUTE and source switching. 1 = Step volume/balance
U12 RS232 Command Enables/disables RS232 commands. 0 = Disable
Interface 1 = Enable
2