Filter
Top Products
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
23
Wireless Transmitter
Belt-pack
• Turn the transmitter ON by pressing and holding the Power button on the side
(approximately 2 seconds).
The LCD
display will appear.
• Open the plastic door by depressing the latches on each side.
• Use the “up” and “down” buttons to select a screen that shows the current channel.
• To change the channel press and hold the “SET” button until there is a blinking cursor on the LCD display window
(approximately 3 seconds).
• Use the “Up” and “Down” buttons to set the channel to match the receiver.
• Press and hold the “SET” button again until the blinking cursor disappears
(approximately 3 seconds).
TT
TT
T
ransmission Frequency in MHz: ransmission Frequency in MHz:
ransmission Frequency in MHz: ransmission Frequency in MHz:
ransmission Frequency in MHz: Press the “UP” button once to view the transmission frequency in MHz of the currently
selected channel.
Toggle
DOWN
Toggle
UP
Set
LightSPEED
Mute
Button
Red LED
Door
Latch
LCD
Display
ON/OFF
Switch
Setup Screens selectable with
the UP and DOWN Arrow Buttons
CH: 001
CH: 001
720. 250M
LS
BP-900
NiMH
AKLN
Channel Selection – Belt-pack TChannel Selection – Belt-pack T
Channel Selection – Belt-pack TChannel Selection – Belt-pack T
Channel Selection – Belt-pack T
ransmitterransmitter
ransmitterransmitter
ransmitter
Once a channel has been selected on the receiver, you now need to select that same channel on the belt pack transmitter.
NOTE: Transmitters and receivers are available in 5 different frequency groups. Verify that the letter code that blinks
on the receiver (when powered ON) matches the letter code on the frequency sticker in the battery compartment of
the transmitter.
CH: 001
720.250M
Operating Instructions
LightSPE
E
D