Filter
Top Products
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
LightSPEED
7100R
UHF TRUE
DIVERSITY
RECEIVER
AB
LOW
BAT
SCAN SQ
RF
CHANNEL
VOL
MaxPWR Min
Remove
Screw
Remove
Screw
19
MANUAL CHANNEL SELECTION:MANUAL CHANNEL SELECTION:
MANUAL CHANNEL SELECTION:MANUAL CHANNEL SELECTION:
MANUAL CHANNEL SELECTION:
6.6.
6.6.
6.
Left Channel Button: Left Channel Button:
Left Channel Button: Left Channel Button:
Left Channel Button: Pressing the Left Channel button changes the
first number (0-9).
7.7.
7.7.
7.
Right Channel Button:Right Channel Button:
Right Channel Button:Right Channel Button:
Right Channel Button: Pressing the Right Channel button changes
the second number (0-9). Once a frequency is selected, you will
need to select the same channel on the corresponding transmitter
(handheld or belt-pack).
Operating Instructions
LightSPEED
7100R
UHF TRUE
DIVERSITY
RECEIVER
AB
LOW
BAT
SCAN SQ
RF
CHANNEL
VOL
MaxPWR Min
Wireless Receiver(s)
NOTE: There are 5 different groupings of 100 channels
available, which are sent out to maximize clear channels
in a specific geography. When the system is powered on,
the two letters that initially blink in the Channel window on
the receiver indicate the frequency group
(see chart on page 30 for further details).
8.8.
8.8.
8.
SQUELCH ADJUSTMENTSQUELCH ADJUSTMENT
SQUELCH ADJUSTMENTSQUELCH ADJUSTMENT
SQUELCH ADJUSTMENT
::
::
: In areas that have very high radio frequency traffic, it may be necessary to adjust the squelch level
to block out potential interference.
••
••
•
MAXIMUM SQUELCH:MAXIMUM SQUELCH:
MAXIMUM SQUELCH:MAXIMUM SQUELCH:
MAXIMUM SQUELCH: (full clockwise) reduces the system reception range, but also reduces the potential for radio
frequency interference.
••
••
•
MINIMUM SQUELCH:MINIMUM SQUELCH:
MINIMUM SQUELCH:MINIMUM SQUELCH:
MINIMUM SQUELCH: (full counterclockwise) maximizes reception range, but also increases the potential for radio
frequency interference.
Installing or Replacing a Receiver Module:Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:Installing or Replacing a Receiver Module:
Installing or Replacing a Receiver Module:
Make sure the power to the
Delta X system is turned OFF.
Remove the two screws securing the module
or filler panel using a small Phillips screwdriver. To remove the module,
use a small flat-blade screwdriver. Carefully insert the blade under the face
plate edge and nudge it outward. Grasp the edges with both hands and slide
outward. Install the new module by aligning it with the guide rails and sliding
all the way in to engage the connector at the rear of the module.
Replace the two screws.
100-channel UHF Receiver Module
LightSPEED
7100R
UHF TRUE
DIVERSITY
RECEIVER
AB
LOW
BAT
SCAN SQ
RF
CHANNEL
VOL
MaxPWR Min
6 7
8