LightSpeed Technologies X12 Speaker System User Manual


 
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662
22
Wireless Transmitter
Handheld Microphone
•Switch the transmitter power off.
•Insert the small DC plug
into the jack on the bottom
of the transmitter.
•Plug the other end of the charger
into any standard 110 VAC outlet.
•The Red LED on the charger will light
indicating that charging is in progress.
•When the batteries are fully charged,
the light on the charger will turn green.
A full charge can take up to 8 hours.
REPLACING THE BAREPLACING THE BA
REPLACING THE BAREPLACING THE BA
REPLACING THE BA
TTERIESTTERIES
TTERIESTTERIES
TTERIES
1.1.
1.1.
1. To replace the batteries, unscrew the end cap to reveal the battery compartment.
2.2.
2.2.
2. Remove or replace the batteries as shown. The microphone requires two AA sized batteries stacked end to end.
3.3.
3.3.
3. Note the polarity in the battery compartment.
Typical battery life is about 8 hours.
CHARGING THE BACHARGING THE BA
CHARGING THE BACHARGING THE BA
CHARGING THE BA
TTERIES (NiMH Rechargeable Batteries ONLTTERIES (NiMH Rechargeable Batteries ONL
TTERIES (NiMH Rechargeable Batteries ONLTTERIES (NiMH Rechargeable Batteries ONL
TTERIES (NiMH Rechargeable Batteries ONL
Y)Y)
Y)Y)
Y)
Make sure there are NiMH Rechargeable Batteries in the transmitter before plugging in the charger.
WARNING: Do not attempt to charge alkaline batteries. They can
overheat and expand, creating a significant hazard and damaging
the transmitter.
(This is not covered by warranty.)
Transmitter
Charger
Charger
Connector
Charger Status LED
• RED = charging in progress
• GREEN = batteries fully charged
LOCK SET
HM-900
Handheld Microphon
e
End View
2
3
ON
1
End Cap
IMPORTANT! Replace batteries with the same type, (alkaline or NiMH),
that were installed in your handheld microphone.
Operating Instructions
O
N