Filter
Top Products
17
Troubleshooting
Symptom
No power.
No sound.
The unit does not
start playback.
The remote control
does not work
properly.
Cause
• The power cord is disconnected.
• The audio cables are not
connected securely.
• The power of the external source
equipment is switched off.
• No disc or tape is inserted.
• An unplayable disc or tape is inserted.
• The disc is placed upside down.
• The disc is not placed within the
guide.
• The disc is dirty.
• The remote control is not pointed at
the remote sensor of the unit.
• The remote control is too far from the
unit.
• There is an obstacle in the path of the
remote control and the unit.
• The batteries in the remote
control are exhausted.
Correction
• Plug the power cord into the wall
outlet securely.
• Connect the audio cable into the
jacks securely.
• Switch on the external source
equipment.
• Insert a disc or tape.
• Insert a playable disc or tape.
• Place the disc with the playback
side down.
• Place the disc on the disc tray
correctly inside the guide.
• Clean the disc.
• Point the remote control at the
remote sensor of the unit.
• Operate the remote control
within about 23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new
ones.
4. Maintenance and Service
Maintenance
and Service
AP_LX-M150A(ENG) 3/2/06 9:54 PM Page 17