LG Electronics LX-M150 Stereo System User Manual


 
13
Operation
Presetting the Radio Stations
You can preset 50 stations for FM and AM.
Before tuning, make sure that you have turned
down the volume to the minimum.
1. Press TUNER/BAND to select the FM or AM
you want in the display window.
Every time you press TUNER/BAND, FM and
AM changes alternately.
2. Press TUNING (
+/-
) on the front panel until
the frequency indication starts to change,then
release.
Scanning stops when the unit tunes in a sta-
tion.
otes
•Tuning in automatically
Press TUNING (+/-) for more than 0.5 seconds.
•Tuning in manually
Press TUNING (
+/-
) briefly and repeatedly.
3.
Press PROGRAM/MEMO. on the front panel
A preset number will flash in the display window.
4. Press PRESET (
+/-)
(or PRESET( )on
the remote control) to select the preset num-
ber you want.
5. Press PROGRAM/MEMO.
The station is stored.
6. Repeat steps 3 to 6 to store other stations.
To clear all the memorized stations
Press and hold PROGRAM/MEMO. on the front
panel for about two seconds, “CLEAR” appears
in the display window and then press CLEAR,
the stations are cleared.
For your reference
If all stations have already been entered, FULL
message will appear in the display window for a
moment and then a preset number will flash. To
change the preset number, follow the steps 5-6.
To recall presets
Press and hold PRESET (+/-)
(or PRESET ( ) on the remote control) until the
desired preset number appears or press it
repeatedly.
Listening to the radio
1.Press TUNER/BAND to select the FM or AM
you want in the display window.
The last received station is tuned in.
2.Press PRESET (
+/-
) (or PRESET ( ) on
the remote control) repeatedly to select the
preset station you want.
- Each time you press the button, the unit
tunes in one preset station at a time.
3.
Adjust the volume by pressing VOLUME
CON-
TROL KNOB on the front panel or VOLUME
() on the remote control repeatedly.
To listen to non-preset radio stations
Use manual or automatic tuning in step 2.
For automatic tuning, press and hold TUNING
(
+/-
) on the front panel.
To turn off the radio
Press POWER to turn the unit off or select
another function mode (CD, TAPE or AUX).
For your reference
If an FM program is noisy
Press MODE/RIF so that “
STEREO
disappears in the display window. There will
be no stereo effect, but the reception will
improve. Press MODE/RIF again to restore
the stereo effect.
To improve reception Reposition the supplied
antennas.
otes
Use MODE/RIF (Radio Interference Filter)
function to switch to MONO reception if stereo
reception is distorted by noise.
When recording the MW(AM) broadcast, beat
noises may occur. If it does, press MODE/RIF
once
.
/
/
/
/
AP_LX-M150A(ENG) 3/2/06 9:54 PM Page 13