Filter
Top Products
IB-HT400-WM-E-122502
1. Insert the stereo audio cables (included) into the TV/VCR AUDIO INPUT L (left=white) and R (right=red) jacks on
the back of your HOME THEATER SYSTEM, and into the corresponding AUDIO OUT jacks on your VCR, this will
allow your VCRs sound to play through your HOME THEATER SYSTEM.
NOTE: Your VCRs sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the VCR (2 channel, STEREO). For Dolby Pro Logic
(5.1 channel) sound reproduction, press the SURROUND button. The sound will come out of all 5 speakers
plus the subwoofer.
2. Connect your VCR to your TV using a coaxial antenna cable (probably already connected), your VCRs picture
will go to your TV through the antenna connection.
3. Connections of your other antenna cables are not changed when you add your HOME THEATER SYSTEM.
4. Insert the AC power cord into an AC outlet.
5. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
POWER button on the REMOTE to turn the set on (or off).
6. Press the SOURCE button several times till the TV/VCR indicator lights.
7. Make sure your VCR is on and follow your VCRs instructions.
8. Go to Page 20 for detailed instructions.
TV + VCR CONNECTIONS
14
Home Theater System + TV + VCR
BACK OF HT-400
HOME THEATER
YOUR VCR
YOUR TV SET
ANTENNA CABLE
(NOT INCLUDED)
(unchanged, same as before)
CABLE OR OFF-AIR SIGNAL
(unchanged, same as before)
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).