Filter
Top Products
Model KPM7200 KPM7200 Powered Mixer
Output Power 200W 4 ohms @ 5% THD
160W 4 ohms @ 0.4% THD
Frequency Response 20Hz-20kHz Actual response is tailored to speaker cabinet for
accurate acoustical response.
Total Harmonic Distortion less than 0.4% Measured at 1VRMS (0dBv) at record output,
effects send, or insert output
Hum & Noise -115dB Mic Input, Rs=150 ohm, 20-20kHz
-60dB Residual Noise, all level controls 0% (minimum)
-50dB Nominal System Noise, all level controls at 50%
System Gain All measurements made at 1kHz
77dB Mic to Power Amp Out (Ch 1 - Ch 5)
60dB Line to Power Amp Out (Ch 1 - Ch 7)
70dB Instrument to Power Amp (Ch 6 - Ch 7)
36dB Playback to Power Amp
50dB Mic to Record Output
44dB Mic to Effects Send
50dB Mic to Preamp Output
50dB Mic to Monitor Output
Crosstalk 80dB Channel to channel, 1kHz
Input Channel Equalization Special curve that adjusts bass, mid, and treble frequencies
Master Equalization 100 to 10Khz, 7 Band, 1 Octave Graphic, all ±12dB
Digital Effects 24 bit DSP, 8 effects; small room, large room, small hall, large hall,
chorus, chorus reverb, slap back (delay), echo
Phantom Power +15V Applied to all Mic Inputs thru 3.3K resistors
Footswitch Digital effects ON/OFF and Channel ON/OFF (playback remains active)
Power Requirements USA/Canada 120VAC/60Hz, 160W nominal
Europe 230VAC/50Hz, 160W nominal
UK 230VAC/50Hz, 160W nominal
Australia 240VAC/50Hz, 160W nominal
Japan 100VAC/50-60Hz, 160W nominal
Dimensions mm/kg 210 (Height) x 480 (Width) x 270 (Depth), 11 kg
inches/pounds 8 1/4 (Height) x 19 (Width) x 10 5/8 (Depth), 24 lbs
7
KPM7200
Specifications