Filter
Top Products
F. PROCESSOR OPERATION AND
DIGITAL TAPE LOOP
1. Select an input with.the Input switch. Notice the Signal
LED will illuminate when the digital source is turned on
and has linked with the processor. Once this link is com-
plete the processor is ready to pass a signal.
2. Be sure that your preamplifier’s volume control is
completely turned to the OFF (lowest volume) position.
3. Turn ON your components, remembering that the last
component to be energized should be your amplifier. The
amplifier should only-be turned ON after all other com-
ponents in the system have been on for at least two min-
utes. This will ~nsure that there will not be any large
pulse created when the amplifier is turned on.
4. Switch the selector source of your preamp.to thee pgsi
-
tion correlating to your chosen input connection tor the
STEALTH.
5. You may now start playing your digital source, DAT,
CD or satellite.
6. Slowly turn the volume control up to the lowest level
you can hear. Check to see that both channels are work-
lng correctly before advancing the volume.
NOTE: While your STEALTH will perform beautifully
from the moment you turn it on, it requires a minimum
warm up period of 8 hours before it will reach its full.
son!c potential. Discre.te components are utilized in the
analog output stage and the warm up period allows them
to reach thermal equilibrium.
fYuO~Uh
r
installation is now complete. Sho.uld you have any
er questions which are not covered in the remainder
of this manual, contact your authorized Krell dealer. We
wish you many hours of listening fulfillment.
7