Krell Industries Stereo Preamplifie Stereo Amplifier User Manual


 
D. BASIC INSTALLATION
AND OPERATION
Before you install the STEALTH into your sy.stem we
recommend that you follow these g.uidelines in choosing’
the location. This will facilitate a clean, trouble-free
installation.
CAUTION: When making connections to this component
or any other, make sure tlie power amplifier is OFF and
the preamplifier is in the MUTE or STANDBY mode.
1. Although well shielded, the processor should not be
p.laced in close proximity to hum-sensitive components
~i.e. preamps, turntables, tuners, etc.)
2. As with any high quality, component, ensure that the
vent openings in the chassis are ]~ree from obstruction,
allowing the processor to dissipate heat created by its
highly regulated power supply and high bias Class A
output stage.
3. Place the unit on a clean, level surface away from
excessive heat or moisture.
4. Connect the AC power cord to the back of the unit.
Once the power cord is secured, plug the other end into
an AC outlet. The .O. degree, Source and Coax 1 LEDs
will illuminate, indicating the digital signal processor is
powered.
S.hould y~our u.nit not perform as described above, unplug
tlae unit trom the AC outlet and contact your local Krell
dealer or the Krell factory.
NOTE: While the STEALTH has superb regulatio
9
and
does not require a dedicated AC circuit, we strongly
advise, against any connections through extension cords
or multiple AC adaptors. High quality 15 amp grounded
AC strips are acceptable.
CAUTION: Do not remove or bypass the ground pin on
the end of the AC cord. This may cause RFI (radio fre-
quency interference) to be induced into your playback
system.
4