Filter
Top Products
t~. Due to the exposed nature of the laser assembly is
ere a possibility of damage through laser radiation?
A. No. There is. an optical sensor under the CD when it is
positione~l on tlae transport hub. This allows the MD-10
to p.rohibit the laser from turning on wlaen it is not cov-
erecl with a CD.
a~I own many CDs that have CD Rings on them. Am I
le to use these discs with the MD-I(~?
DA. Yes, The MD-10 will accept discs with :’CD Rin.gs".
ue to their very low mass, they will not clamage t~ae
MD-10’s transport. While we can neither affirm nor deny
the benefits dei~ved from the use of CD Rings, we do not
fee! that any type of disc equilibrium device is require.d
witla the MD-10 when properly used with our CD Stabi-
lizer.
CAUTION: We strongly advise against the use of any
type.of additional disc stabilizer. These items add too
mucla mass to the laser servo system and may burn out
the drive.
.Q. Do you recommend the use of Cones or other damp-
ing feet with the MD-10?
A. Due to the extraordinary rigidit.y of our machining and
internal damping, we do not f6el tlaat the MD-10 requires
addit~ional m.ass co.upling or isolation. If you wish to use
an atter-marl~et isolation device, you may do so without
fear of dam. agingthe MD-10. Any device which affixes
permanently to the chassis.or requires a breach of the
external chassis will void tlae warranty.
NOTE: Before any type of. after market device is to be
utilized in conjunction witla the MD-10, please consult
your dealer or the Krell staff for assistance.
tQ. Can I use more than one digital output at the same
lme?
A. Yes, The MD-10 can drive up to four different digital
to analog converters.
Q. Will the MD-10 play CD singles?
A. Yes, the MD-10 will play CD singles.
17