Filter
Top Products
I. MAINTENANCE
.B.e.cause of its superb build quality the MD-10 requires
little maintenance. Should tlie unit become excesslvly
dirty, clean the lens assembly with a camera lens brush
made of a soft material like camel hair. The acrylic top
p!ate and dust cover should be cleaned with the poli~stiing
.kit provided. Read the directions on the containers tor
best polishing results.
REMOTE CONTROL BATTERY INSTALLATION
AND REMOVAL
The batteries in the remote control should be changed
when the tran.sport is no longer un.derstaqding .or cor-
rectly responding to the commanOs sent trom tlae unit.
R~e .move the four socketcap screws from the back portion
ot tlae remote control. Remove the back plate to expose
the battery storage compartment. Refer to the polarity
drawing.w, hile inserting the batteries. Replace the back
plate and insert the four socketcap screws.
FUSE INSTALLATION AND REMOVAL
If the MD-10 does not seem to power-up, unplug the unit
from the AC wall socket and check the fuse.
1. Locate the fuse holder on the back of the unit labled
FUSE. Turn the fuse holder counter clockwise and gently
pull the fuse free from the chassis.
2. Check to make sure the foil in the center of the fuse is
still connected. If you are still unsure, measure the fuse
with an ohm meter to determine if it is intact. The MD-10
uses a 1 amp fast-blow fuse at l15v and a .5 amp fast-
blow fuse at 220v. Should the fuse need replacing, use
only the fuse specified.
3. Place the fuse into .the receptacle and push and tu.m
gently clockwise until the fuse holder is .~ully seated.
Plug the unit into the AC wall socket and press the Power
button.
CAUTION: Should the MD-10 n.ot powe~r-up and
con.tinously blow fuses, unplug the unit tro.m, the AC wall
outlet and contact your Kre-ll dealer or distributor.
15