Filter
Top Products
REMOTE CONTROL
BATTERY INSTALLATION AND REMOVAL
NOTE: Batteries should be replaced when functions from the remote control
become intermittent. The KPS-20 universal remote uses two AAA size 1.5 volt
batteries.
1. With the T-10 torx driver remove the four screws from the remote control
back plate.
2. Remove the back plate to expose the batteries.
3. Remove the old batteries and install new ones, following the battery position
diagram on the plastic battery receptacle.
4. Re-install the back plate and four screws.
5. Check to make sure the remote control is functioning properly.
6. Tighten the four back plate screws.
If you have questions about the remote control operation contact the KRELL
staff for assistance.
2O