Filter
Top Products
Krell SACD Standard 5
Before you install the SACD Standard into your system, review the
following guidelines to choose the location for the SACD Standard.
This will facilitate a clean, trouble-free installation. The SACD
Standard does not require any type of special rack or cabinet for
installation. For the dimensions of the SACD Standard, see
Specifications, on the back cover of this manual.
Place the SACD Standard on a firm, level surface, away from exces-
sive heat, humidity, or moisture. The SACD Standard requires at
least two inches (5 cm) of clearance on each side and at least two
inches (5 cm) of clearance above and below the component to pro-
vide adequate ventilation. Installations inside cabinetry may need
extra ventilation.
Do not place the SACD Standard near hum sensitive components
such as preamplifier phono stages or turntables. Although the SACD
Standard is well shielded, placing it near these components could
create interference and cause hum.
The SACD Standard has superb regulation and does not require a
dedicated AC circuit. Avoid connections through extension cords or
multiple AC adapters. High quality 15 amp grounded AC strips are
acceptable. High quality AC line conditioners or filters may be used if
they are grounded and meet or exceed the unit’s power supply rating
of 100 V
A.
Placement
The SACD Standard incorporates an advanced suspension system and
does not require additional mass coupling or isolation. You may experiment
with feet or cones as long as they are not permanently affixed to the unit.
Any unauthorized modifications to the unit or electronics will void the war-
ranty.
Do not attach enhancement accessories such as rings, mats, or
dampers to individual discs. These accessories may interfere with the
disc transport, resulting in erratic playback and/or poor sound.
Note
IMPORTANT
AC Power
Guidelines