Filter
Top Products
16 Krell SACD Standard
This section provides information about operating the SACD
Standard. See Front Panel /Remote Control Description, on pages
6-9, for more SACD Standard playback features.
Press the back panel power switch (30) labeled “1”. When the SACD
Standard is initialized and in the stand-by mode, the red stand-by
LED (3) on the front panel illuminates. Then press the power button
on the front panel or the SACD key (1) on the remote control, to
place the SACD Standard in the operational mode. When the blue
stand-by LED (2) illuminates, the SACD Standard is in the opera-
tional mode and ready to play a SACD or a conventional compact
disc.
1. Press the open/close button or key (7) to open the disc transport.
2. Place the disc on the transport.
3. Press the open/close button or key again to close the disc trans-
port. Track 1 begins to play, and the front panel display shows the
elapsed track time. The multi-channel layer of an SACD loads
automatically.
4. Press the
SACD/CD button or key (10) to select another disc format
and view available tracks.
5. Adjust the volume level through your system volume control.
6. Press the stop button or key (5) to end disc playback.
7. Press the play button or key (6) to begin playback again, from the
first track.
8. To return the SACD Standard to the stand-by mode, press the
power button or key (1).
If you are playing a two-channel track on a hybrid SACD, and want to
access the tracks on the conventional CD layer:
1.
Press the stop button on the front panel (5) or the stop key (5) on
the remote control. The front panel display reads
STOP.
2.
Press the
SACD/CD button or key (10) twice.
The red LED next to
the
CD label (22) appears in the front panel display and the con-
ventional CD layer begins playing in approximately 30 seconds.
Operating the SACD Standard
How to Play a Disc
Power On
Playing the Conventional
CD Layer of a Hybrid SACD