Filter
Top Products
Remote Control Description
See Figure 2 on page 6
Krell SACD Standard
13
The SACD Standard remote control uses one CR2025 lithium bat-
tery, which is included with the shipment.
To open the battery compartment on the back of the remote control:
1. Place the remote face down on the table.
2. Use your thumbnail or a small jeweler’s or eyeglass screwdriver
to move the small tab toward the center of the remote, while
using your index fingernail or screwdriver to pull down gently on
the slot to the right of the tab. The battery compartment will slide
out.
3. Place the battery, plus side up, in the battery tray.
4. Slide battery compartment back into the remote until you hear a
click.
The remote control is ready for operation.
Do not use a knife or other sharp objects to open the battery compartment;
they will scratch the remote control finish.
Replace batteries when remote control function becomes intermittent.
Remove batteries if the remote control is not used for a long period of time.
Battery leakage can damage the remote control.
Notes
Further information on
battery installation
Battery
Installation
and Removal
Power, transport, and display features are described in the illustration
legend on page 7. All remote features can also be activated via the
buttons on the front panel. Descriptions of special operational fea-
tures are outlined on pages 8-10.