Filter
Top Products
Sleep function
You can activate the sleep function via the SNOOZE button. You can set a
time of up to 90 minutes in ten-minute steps, after which the radio will auto-
matically turn itself off. To do so, first switch the radio off.
• Press the
SNOOZE button. The symbol for the sleep function and
90 (for 90 minutes) will appear.
• Press the
SNOOZE button repeatedly until 90 is displayed to count down
the sleep time in 10 minute steps.
• Either select a sleep time (the sleep symbol remains on the screen)
or press
SNOOZE again until 00 appears on the screen.
The sleep time is now switched off.
Setting the station
• Select the required frequency band (FM, MW, LW or SW), using the
frequency select button.
The corresponding abbreviation will appear on the screen.
• The
UP and DOWN buttons can now be used to set the desired frequency.
• If you keep
UP or DOWN pressed for about three seconds, the automatic
station search will start.
• The search stops as soon as a station with sufficient signal strength is
found.
Setting the MW band
Since the radio transmitter systems differ from one country to another,
you should make the appropriate setting via the reception range setting:
• With the radio switched off, press the button
MODE six times and then
select, using the buttons
UP resp. DOWN, the appropriate reception range
as per the following table:
- 25 -
IB_KH2029_DT46054_LB6 05.01.2010 16:55 Uhr Seite 25