Filter
Top Products
14
2. To view video from the iPod on a TV, you must change one iPod setting.
From the iPod screen, go to Videos / Video Settings. Change “TV” Out to
“Ask”. From this point on, when you select a video on the iPod, the iPod
will ask you to select “TV Off” or “TV On”. Select “TV On” to view on your
TV, or “TV Off” to view on the iPod’s screen. When playing a video, you
will hear the sound through the KS-600, and the picture will be fed to the
TV via the cable attached to (32) or (33). You must select the input on
your TV that this cable is attached to. Details will be found in the TV’s
instruction book.
PLAYING A CD
1. Press the FUNCTION button (5) until CD shows in the main display
window (8).
2. When no CD is present, the display will show “no cd”.
3. Press OPEN/CLOSE (12) to raise the CD protective panel.
4. Mount a CD on the spindle with the label facing out. Be sure that the CD
is firmly held by the grips on the spindle.
5. Press OPEN/CLOSE (12) to lower the CD protective panel.
6. After a few seconds, the main display window (8) will show the statistics
for the disc. The total number of tracks on the disc will be on the left and
the total length of the CD in minutes and seconds is on the right.
7. Press PLAY/PAUSE (14) to start playback of the disc.
8. When playback starts, the display will show the number of the track that is
playing and the elapsed time.
9. Press PLAY/PAUSE
(14) to suspend playback of the disc.
10. To stop playback, press the STOP button (9).
11. To increment or decrement the track, press TUNING UP/DOWN/SKIP
buttons (10 or 13). If pressed and held, these buttons allow
rapid scanning within a track.
12. Press REPEAT (18) to repeat a track or the entire disc. Each push of this
button cycles REPEAT – REPEAT ALL – OFF. Note: Pressing STOP (9),
FUNCTION (5), FM/AM (6), OPEN/CLOSE (12), or STANDBY/ON (3) will
cancel the repeat function.