Filter
Top Products
DN530
Operator Manual 17
Chapter 5: Rear Panel
The rear panel of the DN530 (shown below) has three main connector sections: mains
input, solo bus and the four channels.
Mains input
The mains input section has a mains
IEC socket, below which is a fuse
drawer. Printed to the right are mains
supply voltage and fuse details.
The mains input is an auto-voltage
sensing switch mode power supply that
operates where normal mains voltage
is in the range 100V AC to 240V AC.
The fuse drawer houses the mains fuse
at the rear of a two-compartment
drawer. The front compartment
provides room for a spare. Always replace the mains fuse with one of the same type
and rating, as printed to the right of the fuse drawer.
Channels
There are four similar channel
sections on the rear of the
DN530. Each section comprises
an input and an output XLR
chassis connector, and a 1/4”
TRS connector. These are used
for connecting to external line
level signals, such as a mixing
console’s insert connections.
Mains input Solo bus Four channels
Mains IEC socket
Fuse drawer
External
sidechain input
(1/4” TRS jack)
Input (female
XLR connector)
Output
(male XLR
connector)