Filter
Top Products
Chapter 3: Getting Started
DN530
10 Operator Manual
Connecting the power cable
Making sure that the mains power at the power outlet is off, connect the mains cable
supplied with your DN530 to the mains power outlet and then to the mains socket at
the rear of your unit.
Connecting the audio cables
Making sure that all equipment is switched off, connect the DN530 to the rest of your
audio equipment as shown in the following subsections. For information on balancing,
see “Balanced/unbalanced audio” on page 37.
Channel I/O pin-outs
The following shows the channel I/O pin-outs for the male and female XLR connectors,
on both balanced and unbalanced circuits.
Pin-out Balanced I/O Unbalanced I/O
1 Screen/ground Screen/ground (not connected
at unbalanced end)
2 Hot signal Hot signal
3 Cold signal Ground at unbalanced end
1
Male XLR
chassis
connector
3
2
1
3
2
Female XLR
chassis
connector