Kenwood X-SE7 Stereo System User Manual


 
R-SE7/DP-SE7/X-SE7 (En)
19
Preparation section Basic section Application section Knowledge sections
Hearing sound
Listening through headphones
1 Insert the headphone plug into the phones jack.
÷ Headphones with a stereo mini plug can be connected.
÷ The sounds from all speakers are cut off.
Power Switch Standby
When this system is in standby condition (time display
for the R-SE7, STANDBY indication for DP-SE7, standby
indicator lit for X-SE7), a slight current flows for memory
protection.
At this time also, the remote control can be used for
power ON.
÷ Press again to resume the original volume.
÷ This is also cancelled when the volume is adjusted.
2 Adjust the volume.
Remote control unit
Bass and treble compensation
(N.B.: Natural Bass circuit)
Blinks
Lights
÷ When the TUNER input is selected, it is available only
when the volume is set to 0.
When CD has been selected.
AUTO POWER SAVE function
When the power is ON and neither recording nor
playback is executed for 30 minutes or more, the
power is switched off automatically by this func-
tion. This function can be made active or not active
by the following operation.
Each press switches the modes as follows.
1APS ON..... Auto power save is used.
2APS OFF.... Auto power save is not used.
Press when the power is OFF.
Volume display
R-SE7
R-SE7
The indication changes each time this key is
pressed.
1NB ON1...The high and the low range are
compensated according to the vol-
ume (effective for low volumes).
2NB ON2...The high and the low range are
compensated independent of the
volume.
3NB OFF
R-SE7
R-SE7
Muting the sound temporarily (Remote control unit only)
MUTE
N.B.
phones
volume
control
pure
A
∞∞
down up
pure
MUTE
NB
CD
VOL 2)