Filter
Top Products
6
EN
6543278 901 @!
#% $^
Standby mode
While the standby indicator is lit, a small amount of power is supplied to the system to back up the memory. This is called standby mode. Under the
condition, the system can be turned ON by the remote control unit.
1 POWER ON/STANDBY key *
Use to turn the power ON/STANDBY.
STANDBY indicator
Lights when the power is in the standby
mode.
2 DIMMER key
Use to select the REC MODE. ∞
Use to adjust the brightness of the display.
‹
3 INPUT MODE key 8
Use to switch between the full auto, digital and
analog input.
4 SOUND key •
Use to adjust the sound quality and the ambi-
ence effects.
5 MEMORY key §
Use to presetting of radio stations.
6 BAND key §
Use to select the broadcast band.
7 AUTO/MONO key §
Use to select the auto or manual tuning
mode.
8 Dolby D indicator º
Lights when the receiver is in the Dolby
Digital mode.
DTS indicator º
Lights when the receiver is in the DTS mode.
LOUDNESS indicator £
Lights when the LOUDNESS mode is ON.
9 MULTI CONTROL button &
Use to control a variety of settings.
0 ACTIVE EQ key £
Use to select ACTIVE EQ’s setting.
Display
Speaker selection indicators,
Input channel indicators (The Input
channel indicators lights up to indicate
the channels contained in the input
signal. The "S" indicator lights when the
surround component consists of a single
channel.)
ACTIVE EQ indicator,
96 kHz fs indicator
Frequency display,
Input display,
Preset channel display,
Listen mode display
MUTE indicator
CLIP indicator
Input mode indicators
Listen mode indicators
! VOLUME CONTROL knob ™
Use to adjust the receiver volume.
@ INPUT SELECTOR key ™
Use to select input sources.
# SETUP key &
Use to select the speakers' settings etc.
$ LISTEN MODE key º
Use to select the listening mode.
% FRONT AUX jacks $
^ PHONES jack ¢
Use for headphone listening.
AUTO indicator, ST. indicator,
TUNED indicator, TONE indicator
View when the FRONT AUX jack cover is open.
Main unit
Names and functions of parts
*5484/01-07/EN 04.5.17, 8:34 AM6