Filter
Top Products
43
3 Press the MENU key then press or to select “ ”
(battery saver on) or “
” (battery saver off).
4 Press the MENU key to exit the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.
Note: While the Battery Saver is operating, the LED may flash
green when receiving a QT/DQT signal which does not match
the QT/DQT tone/code set up in your transceiver.
BAttery level indicAtor
When turned ON, the battery level indicator on the display lets
you know approximately how much battery life is remaining.
When turned OFF, the battery level indicator will appear and
blink only when the battery voltage level is low.
When the battery voltage becomes too low while transmitting,
the transceiver stops transmitting, a tone sounds, and the
LED blinks red until you release the PTT switch. Recharge or
replace the battery pack at this time.
High battery power
Medium battery power
Low battery power
Recharge the battery pack
To turn this function on or off:
1 With the transceiver power OFF, press and hold the MENU