Filter
Top Products
EN
11
Using the CD/MP3-CD/WMA-CD/USB device
Preparation
Loading a disc
1 Press CD/USB (CD/USB) button to select CD
mode.
2 Press the area marked [push open] on the top
cover to open the CD door.
3 Place a disc into the tray with the label facing
up.
Push surrounding of the disc center hole until it is
locked to the center part of the tray.
4 Close the CD door.
For a normal CD, the total playtime and total
number of tracks will appear in the display.
For an MP3-CD and WMA-CD, the total album
number and total le number will appear on the
display.
⁄
• To remove the disc, press the area marked [push open], grasp
the disc by its edges, and carefully pull it out.
Inserting a USB device
1 Press CD/USB (CD/USB) button to select USB
mode.
2 Insert a USB device to the USB connector on the
front panel.
Playback automatically starts.
⁄
• To ensure good system performance; wait until the unit
completely reads the disc/USB device before proceeding.
• If the disc compartment is not loaded with a disc, “NO DISC” is
displayed. If the disc is unreadable, “NO PLAY” is displayed.
• If no USB device is inserted, “NO USB” is displayed. If the USB
device is unreadable, “NO DATA” is displayed.
• For audio les, reading time may exceed 10 seconds due
to the large number of songs compiled into one disc/USB
device.
• For audio les, “A” on the display represents ALBUM.
• For audio les, the total album number on the display
indicates the number of all the albums recorded in the disc/
USB device.
•
The icon “MP3” appears only when an MP3- le is played. It does
not appear when playing a WMA- le.
Playing a disc/USB device
Press PLAY/PAUSE 6 (6) button to start
playback.
The track/ le number and elapsed playing time of
the current track/ le appear on the display.
⁄
• To interrupt playback, press PLAY/PAUSE 6 (6) button.
The playing time starts ashing.
To resume playback, press PLAY/PAUSE 6 (6) button
again.
• To stop playback, press STOP 7 (7) button.
Selecting a desired track/passage
To select a desired track
Press SEARCH/TUNING 4 or ¢ (4 or ¢
search +/–) button repeatedly until the desired
track appears on the display.
⁄
• If playback is stopped, press PLAY/PAUSE 6 (6) button
to start playback.
• The digit buttons, 0–9 on the remote control unit can also be
used to select a track.
Press the digit buttons as shown below:
To select track 2 : 2 and ENTER
To select track 23 : 2, 3 and ENTER
To select track 120 (Audio le only) : 1, 2 and 0
To search for a particular passage during
playback
Press and hold
SEARCH/TUNING 4 or ¢ (4 or
¢
search +/–
)
button and released it when the
desired passage is located.