Filter
Top Products
LSF-1010 (EN)
8
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
NEDERLANDS
Setting Up the Satellite Speakers
For standard setup, mount each speaker
to a stand as described below.
As an alternative to the standard
setup, it is also possible to mount the
speakers onto a wall or to set them up
without the stand. For information
about setup alternatives, see page 18,
“Other Ways to Set Up the Satellite
Speakers.”
1. Attach the speaker to the arm.
Use the speaker screw and washer removed from the satellite speaker to make the
attachment.
FIRST: Attach speaker cord.
Connect speaker cord to the terminals on the bottom of the stand base.
1 Remove the screw and washer from
the rear of the satellite speaker.
2 Pass the cord through the arm.
3 Use the screw and washer to fasten the
speaker to the arm.
Adjusting the Speaker Angle
You can adjust the angle of the speaker
by moving the screw to a different lo-
cation on the arm.
Use a coin or screw-
driver to turn loosen
the screws.
Remove the plastic
insulation from each
wire tip, and twist
the exposed metal
wire.
Be sure that the screw
head makes contact
with metal only, not
with plastic insulation.
Curl the wire around
the thin part of the
corresponding screw,
and then tighten the
screw.
Satellite speaker
Screw
Washer
Cord
Pass the cord through the arm.
Cord
Screw
Washer
Arm
Location of screw
controls the angle.
White
stripe
Set the cord into
cord cramp.