Filter
Top Products
LSF-1010 (EN)
16
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
NEDERLANDS
You can adjust the position of the speaker by changing the height and angle of
the arm.
Getting Ready to Adjust
Loosen the two arm screws holding the arm in place (one screw on each side of
the arm), so that you can move the arm up and down.
1. Remove the screw cap covering each arm screw.
To remove each cap, grasp it at the cir-
cumference and peel it off.
To replace the cap, place it over the screw
head and lightly press it along the circum-
ference.
Adjusting the Satellite Speaker Position
Adjusting the arm height
Adjusting the arm angle
2. Loosen the two screws.
Use a coin to turn each screw.
• Once you have loosened both screws you
will be able to move the arm up and down,
or to remove it entirely.
Adjusting the Arm Height
Move the arm up or down to raise or lower the speaker.
1. Loosen the two arm screws as described above, so that the arm can move up
and down.
2. Raise or lower the arm to the desired height, then retighten the two screws.
3. Replace the screw caps.
You may now want to readjust the angle of the speaker on the arm. You can do this
by loosening the screw holding the speaker to the arm, repositioning the screw, and
then retightening it. See “Adjusting the Speaker Angle,” on page 8.
Screw
caps
Use a coin to turn the screws
(one screw on each side).
Screw
Move arm up or down to
desired position.
Use a coin to retighten
the screws.