Filter
Top Products
–
+
–
+
–
+
–
+
–
+
FRONT • L
FRONT • R
REAR • L
REAR • R
FRONT
P.CONT.OUT
ANT.
CONT.
Rear right output (Red)
Rear left output (White)
Front left output (White)
(KRC-477R only)
Front right output (Red)
(KRC-477R only)
KENWOOD disc changer
/ DAB control input
FM/AM antenna
input
Antenna Cord (ISO)
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
To connect the Disc changer or
DAB unit, consult each manual.
NOTE
Wiring harness
(Accessory1)
TEL mute terminal
Fuse (10A)
Plug (P.32)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
To connect the KENWOOD
navigation system, consult
your navigation manual.
NOTE
When only two speakers are being connected to
the system, connect the connectors either to both
the front output terminals or to both the rear
output terminals (do not mix front and rear). For
example, if you connect the + connector of the
left speaker to a front output terminal, do not
connect the - connector to a rear output
terminal.
2CAUTION
If you connect the ignition cable (red) and the
battery cable (yellow) to the car chassis
(ground), you may cause a short circuit, that in
turn may start a fire. Always connect those
cables to the power source running through
the fuse box.
2WARNING
Ignition cable (Red)
Battery cable (Yellow)
Ground cable (Black) - (To car chassis)
Ignition key
switch
Car fuse
box
(Main
fuse)
ACC
Car fuse box
Battery
Power control/ Motor antenna
control cable (Blue/White)
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
If no connections are made, do not cut the tube off from
the edge of the cable.
English
— 30 —
Connecting Cables to Terminals
ISO connector unsupported car (KRC-477R/377R/32R only)
■
Power Control terminal
(P31)