Filter
Top Products
4
GETTING STARTED
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display shows:
“CANCEL DEMO” \ “PRESS” \ “VOLUME KNOB”
1 Press the volume knob.
[YES]
is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1 Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select
[SETTINGS]
, then press the knob.
3 Turn the volume knob to select
[CLOCK]
, then press the knob.
4 Turn the volume knob to select
[CLOCK ADJ]
, then press the knob.
5 Turn the volume knob to adjust the hour, then press the knob.
6 Turn the volume knob to adjust the minute, then press the knob.
Press 4
/
¢ to move between the hour and minute adjustment.
7 Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode directly while in clock
display screen.
Then, perform steps 5 and 6 above to set the clock.
Set the initial settings
1 Press SRC to enter
[STANDBY]
.
2 Press the volume knob to enter
[FUNCTION]
.
3 Turn the volume knob to select
[INITIAL SET]
, then press the knob.
4 Turn the volume knob to make a selection (see the following table), then press the
knob.
5 Press and hold to exit.
• To return to the previous hierarchy, press .
3
1
2
EN_KMM-100[KN]2.indd 4EN_KMM-100[KN]2.indd 4 11/5/12 5:32:38 PM11/5/12 5:32:38 PM