Filter
Top Products
15
ENGLISH |
Basic procedure
1
Remove the key from the ignition switch, then disconnect the · terminal of the car battery.
2 Connect the wires properly. (See Wiring connection.
(
➜
16)
)
3 Install the unit to your car. (See Installing the unit (in-dash mounting).)
4 Connect the · terminal of the car battery.
5 Reset the unit.
(
➜
3)
INSTALLATION / CONNECTION
Do the required
wiring. (
➜
16)
Dashboard of
your car
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
How to remove the unit
Installating the unit (in-dash mounting)
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate from
the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
the supplied screws.
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
EN_KMM-100[KN]f.indd 15EN_KMM-100[KN]f.indd 15 12/13/12 10:21:50 AM12/13/12 10:21:50 AM