Kenwood KMM-100 Stereo Receiver User Manual


 
11
ENGLISH |
AUDIO SETTINGS
While listening to any source...
1 Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select
[AUDIO CTRL]
, then press the knob.
3 Turn the volume knob to make a selection (see the following table), then press the knob.
Repeat step 3 until the desired item is selected or activated.
4 Press and hold to exit.
(or using RC-406)
1 Press AUD to enter
[AUDIO CTRL]
.
2 Press 5/ to make a selection, then press ENT 38.
• To return to the previous hierarchy, press .
Default:
XX
SUB-W LEVEL –15 to +15 (0): Adjusts the subwoofer output level.
BASS LEVEL –8 to +8 (0):
Adjusts the level to memorize for each source. (Before making an adjustment,
select the source you want to adjust.)
MID LEVEL –8 to +8 (0):
TRE LEVEL –8 to +8 (0):
PRESET EQ NATURAL/ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset equalizer
suitable to the music genre. (Select [USER] to use the customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS
LOUD LV1/ LOUD LV2: Selects your preferred low and high frequencies boost to produce a well-
balanced sound at a low volume level. ; OFF: Cancels.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
SUB-W SET ON: Turns on the subwoofer output. ; OFF: Cancels.
DETAIL SET
LPF SUB-W THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/ 160HZ: Audio signals with
frequencies lower than 85 Hz/ 120 Hz/ 160 Hz are sent to the subwoofer.
SUB-W
PHASE
REV (180°)/ NORM (0°): Selects the phase of the subwoofer output to be in line with the speaker
output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for
[LPF SUB-W].)
SUPREME
SET
ON: Creates realistic sound by interpolating the high-frequency components that are lost in audio
compression. ; OFF: Cancels. (Selectable only when playing back a USB device.)
VOL OFFSET
(Default: 0)
–8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume adjustment level of each source.
(Before adjustment, select the source you want to adjust.)
[SUB-W LEVEL]
/
[SUB-W SET]
/
[LPF SUB-W]
/
[SUB-W PHASE]
is selectable only if
[SWITCH PRE]
is set to
[SUB-W]
. (
5
)
[SUB-W LEVEL]
/
[LPF SUB-W]
/
[SUB-W PHASE]
is selectable only if
[SUB-W SET]
is set to
[ON]
.
EN_KMM-100[KN]4.indd 11EN_KMM-100[KN]4.indd 11 11/29/12 10:02:49 AM11/29/12 10:02:49 AM