Kenwood VR-806 Stereo System User Manual


 
21
EN
Frequency display
TUNED” is displayed when a
station is received.
ST.” lights when a broadcast
is being received in stereo.
Recording
3 Press and hold the DIMMER key for more than 2 seconds to select
the A-REC or M-REC mode during digital input.
1 Rec mode off : The digital input record mode is switched off.
2 A-REC mode : The digital input signals (DTS, Dolby Digital,
or PCM) are identified automatically and
converted into stereo signals that are ready
for recording.
3 M-REC mode : The input signal type at the moment this
mode is selected is held throughout this
mode.
When the M-REC mode is selected, the digital input signal is
converted to stereo signals (down-mix). But once the digital signal
is chaned to other signal, no signal is output.
When the A-REC mode is selected, the digital input signal is
converted to stereo signals even if the digital signal is changed.
For A-REC mode:
For M-REC mode:
4 Start playback, then start recording.
If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
Listening to radio broadcasts
This model can store up to 40 stations in the memory and recall them by
one-touch operation.
Tuning radio stations
AM” or “FM” indicator
appears in the display
AUTO” indicator lights up in the display.
1
Use the INPUT SELECTOR knob or TUNER key to select the
tuner.
2
Use the BAND key to select the desired broadcast band.
Each press switches the band
as follows:
1 FM
2 AM
3
Use the AUTO key to select the desired tuning method.
Each press switches the tuning method as follows:
1 AUTO lit (auto tuning)
2 AUTO not lit (manual tuning)
Normally, set to “AUTO” (auto tuning). If the radio waves are weak
and there is a lot of interference, switch to manual tuning. (With
manual tuning, stereo broadcasts will be received in monaural.)
4
Use the MULTI CONTROL knob or MULTICONTROL
%
/
keys, or TUNING
1
/
¡
keys to select the station.
Auto tuning : The next station is tuned automatically.
Manual tuning : Turn the knob (press the key) to select the desired
station.
MULTI CONTROL
INPUT SELECTORBAND
AUTO
MULTI
CONTROL
TUNER
AUTO
BAND
TUNING
1
/
¡
04.1.22, 1:19 PM21