Kenwood VR-806 Stereo System User Manual


 
19
EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1 “TUNER”
2 “CD/DVD”
3 “TAPE” or “MD”
4 “VIDEO1”
5 “VIDEO2”
6 “DVD/6CH” (VR-806 : “DVD”)
7 “AUX”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
INPUT SELECTOR
VOLUME CONTROL
Input
Selector
VOLUME
Normal playback
Adjusting the sound
Adjusting the Tone (remote control only)
You can adjust the sound quality when this model is in the PCM stereo
and analog stereo mode.
1 Press the TONE key to select the TONE mode.
2 Use the MULTI CONTROL knob or MULTI CONTROL %/ keys to
select TONE ON/OFF.
3 When in TONE ON selection, press the TONE key for the following
displays.
BASS : Select this to adjust the low frequency range.
TREB : Select this to adjust the high frequency range.
4 Use the MULTI CONTROL knob or MULTI CONTROL %/ keys to
adjust the sound quality.
The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
Once-touch low frequency emphasis (Bass Boost)
(remote control only)
You can adjust the sound quality when this model is in the PCM stereo
and analog stereo modes.
Press the BASS BOOST key.
Press the key once to select the maximum (+10) low frequency
emphasis setting.
TONE will automatically be turned ON.
This key does not function when this model is in the sound quality
or ambience effects adjustment mode. £~
Switching back to the previous setting
Press the BASS BOOST key again.
VOLUME
MUTE
BASS BOOST
MULTI
CONTROL
ACTIVE EQ
VOLUME CONTROL
PHONES MULTI CONTROL
TONE
ACTIVE EQ
LOUDNESS
SPEAKERS ON/OFF
MUTE
04.1.22, 1:19 PM19