Filter
Top Products
49
EN
Remote control unit
Cause
• No setup codes registered for the respective
input(s).
• The remote control is set to a different opera-
tion mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source compo-
nent.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
• Register a setup code at the respective input(s).
er
• Press the source select keys or SOURCE
keys to select the appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”.
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the source select keys or SOURCE
key to activate the operation mode for the
component you want to control before
operation. w
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
In case of difficulty
•VR6070/42-52/EN 3/26/02, 2:46 PM49