Kenwood KRF-V7090D Stereo System User Manual


 
23
EN
ENGLISH
Recording
Recording audio (digital sources)
Switch on the REC MODE to record a digital input source.
Usually use the REC MODE AUTO to record audio input sources. When
the digital mode changes during recording in the REC MODE AUTO, the
audio input source may be interrupted momentarily.
Recording music in REC MODE AUTO or MANUAL
Input Selector keys
Input Selector
keys
DIMMER
1 Use the Input Selector keys to select the source (CD/DVD, DVD/
6CH, VIDEO 2, VIDEO 3) you want to record.
2 Set the MD or TAPE recorder to record.
3 Press and hold the DIMMER key for more than 2 seconds to select
the REC MODE AUTO or MANUAL.
1 REC MODE off : The digital input record mode is switched
off.
2 REC MODE AUTO : The digital input signals (DTS, Dolby Digi-
tal, or PCM) are identified automatically
and converted into stereo signals that
are ready for recording.
3 REC MODE MANUAL : The input signal type at the moment this
mode is selected is held throughout this
mode.
When the REC MODE MANUAL is selected, the digital input signal
is converted to stereo signals (down-mix). But once the digital signal
is changed to other signal, no signal is output.
When the REC MODE AUTO is selected, the digital input signal is
converted to stereo signals even if the digital signal is changed.
For REC MODE AUTO :
L
SSB
SL SR
C R
SP MUTE
AB CLIP
LFE
L
SSB
C R
SP MUTE
AB CLIP
LFE
SL SR
DIGITAL STEREO
AUTO DETECT
DIGITAL STEREO
AUTO DETECT
For REC MODE MANUAL :
L
SL S SB SR
C R
LFE
SP MUTE
AB CLIP
DIGITAL STEREO
L
SL S SB SR
C R
LFE
SP MUTE
AB CLIP
DIGITAL STEREO
4 Start playback, then start recording.
If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
05.2.8, 11:57 AM23