Filter
Top Products
7
CD-224M/DPF-J5010 (En)
System connections
Notes
Notes
SL16 XS 8
j
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
Connection to digital amplifier or MD
Connect the DIGITAL OUT (OPTICAL) jack to the digital input jack
of the amplifier, DAT recorder, MD recorder, etc., using an optical
fiber cable which are commercially available in audio stores.
÷When using an optical fiber cable to connect this unit to a digital
amplifier, insert the plug straight into the jack until a snap sound is
heard.
÷Be careful not to bend, coil, or bundle the optical fiber cable.
÷Optical fiber cables available on the market may not always be able to
be used with this player. If your cord cannot be used with this unit,
consult the store from which you purchased the cord or your nearest
dealer.
Connection to a general-use amplifier
Use the provided audio cords to connect the OUTPUT jacks of this
unit to the CD input jacks (or AUX jacks) of the amplifier.
SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connec-
tions according to the groups of terminal symbols shown below.
[XS8] Mode : lets you combine F, f, and ƒ terminals
[SL16]Mode : for
terminals only
This unit is compatible with both [XS8] and [SL16] modes.
Select the mode according to the connected components.
6
÷Do this operation after completing all connections.
(Ensure that the power plug is not connected.)
1. If your amplifier or receiver does not have a system control
terminal, do not connect any system control cords to the
system control terminals on the other components.
2. Do not connect system control cords to any components
other than those specified by KENWOOD. It may cause a
malfunction and damage your equipment.
3. Be sure the system control plugs are inserted all the way
in to the system control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from a CD. Also, the simple CCRS operation enables great recordings from
CDs.
See the operating instructions supplied with your cassette deck for details.
Optical fiber cable
Amplifier or receiver
This unit
Cassette deck