Filter
Top Products
English
|
11
System Q
Selecting the best sound setting preset for
different types of music.
1 Select the source to adjust
Press the [SRC] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "SYS.Q" is
displayed above the [1] button.
Refer to <Notes on Multi-function Key System>
(page 9).
3 Enter System Q mode
Press the [1] ("SYS.Q") button.
4 Select the Sound type
Push the Control knob towards [4] or
[¢].
Each time the knob is pushed, the setting
switches as shown below.
Sound setting Display
User memory "USER"
Rock "ROCK"
Pops "POPS"
Easy "EASY"
Top 40 "TOP 40"
Jazz "JAZZ"
Natural "NATURAL"
• User memory:
The values set on the <Audio Control> (page 11).
• Change each setting value with the <Speaker
Setting> (page 13).
First, select the speaker type with the Speaker setting.
Audio Control
1
Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Rear Volume *
1
"Rear Volume" 0 — 35
Subwoofer level*
2,3
"Sub-W Level" –15 — +15
Bass level*
4
"Bass Level" –8 — +8
Middle level*
4
"Middle Level" –8 — +8
Treble level*
4
"Treble Level" –8 — +8
Balance "Balance" Left 15 — Right 15
Fader*
3
"Fader" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
• *
1
You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "ON".
• *
2
You can control this item when <Subwoofer
Output> (page 13) is set to "SW ON".
• *
3
You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "OFF".
• *
4
You can adjust these items in detail. Refer to
<Adjusting the detail of Audio Control>(Page 12).
(Function of the KDC-X790)
• *
4
Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [ANG]
and [ATT] button.