Filter
Top Products
46
EN
÷ Place the disc properly, with the label side facing upward.
÷ Clean the disc referring to "Disc handling precautions".
r
÷ Refer to "Caution on condensation" and remove the condensation
by evaporation.
e
÷ Press the CD 6 key.
÷ Clean the disc referring to "Disc handling precautions".
r
÷ Clean the disc referring to "Disc handling precautions". r
÷ Install the unit in a place not subject to vibrations.
Remedy
CD player section
A CD is placed in the player but it cannot be
played.
Sound is not produced.
Sound skips.
Symptom
Cassette deck section
÷ Clean the head referring to "Maintenance". e
÷ The tape is wound too tight due to irregular winding.
÷ Play a recorded tape.
÷ Press operation keys in more than a few seconds after closing
the cassette holder. *
÷ Change the tape transport direction or reverse the tape insertion
orientation.
*
÷ Press in stop mode.
÷ Clean the head referring to "Maintenance".
e
÷ Try another tape.
÷ The recording level is not set properly (when the AUX input is
recorded).
Adjust the AUX input level. fl
÷ Demagnetize the head referring to "Maintenance". e
÷ Install the system at a distance from other electric appliances and TV.
÷ Set the TAPE EQ. to on.
(
÷ Clean the head referring to "Maintenance". e
÷ Wind the tape again by fast forwarding, rewinding or playing
from an end to the other.
*(
÷ Use a cassette with an unbroken recording protect tab or block
the hole.
r
÷ Close the holder completely. *
÷ Set the input selector to the source to be recorded. ¶
÷ Change the tape transport direction or reverse the tape insertion
orientation.
*
RemedySymptom
Sound cannot be produced by pressing the play
key.
No operation occurs even when an operation
key is pressed.
The cassette holder cannot be opened by
pressing "0 push open".
Sound is harsh or high frequencies are not re-
produced.
Sound is distorted.
Noise is noticeable.
Sound vibrates.
Recording cannot be started by pressing the
record key.
÷ Replace with new batteries. #
÷ Operate the unit inside the remote controllable range. #
Symptom
Remote control operation is not possible.
Remedy
Remote control unit
In case of difficulty