Filter
Top Products
Recording on TAPE
27
EN
5.
Start recording.
4.
Select the source to be recorded.
Select an input source other than
"TAPE"
1 Press the rec key.
2 Play (or tune) the input source to be recorded.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
CD
TUNER (Broadcasts)
AUX (External input) [Adjusting the AUX input level fl]
÷ If a CD has already been
loaded, it starts to play
now. Press the 7 key to
stop it.
Pause the recording
÷ Press the rec key during recording. It pause after
leaving a non-recorded blank of 4 seconds. (Press
the key again to resume recording.)
Lights
Stop the recording
Select the reverse mode. (
3.
Set the recording condition.
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction, only one side of tape can be recorded regardless of
the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
The character information display shows the re-
cording input source.
Tuning
Mode
time
CD
\
\
Example:
To select the CD input
While recording an AM broadcast, beat sound can be minimised by
switching the BEAT switch on the CD tray.
mode
set/sound
rec
rec
BEAT
1
2
Select 1 or 2.