Filter
Top Products
14
|
English
Troubleshooting Guide
What might appear to be a malfunction in your
unit may just be the result of slight misoperation
or miswiring. Before calling service, first check the
following table for possible problems.
? The HD Radio mode cannot be selected.
✔ The connection wire is not connected.
☞ Use the connection wire to connect the
control unit and the HD Radio tuner.
✔ HD Radio tuner is connected to KCA-S210A or
other units.
☞ Connect the HD Radio tuner directly to the
control unit.
? Nothing happens when the buttons are pressed.
✔ The computer chip in the unit is not functioning
normally.
☞ Press the reset button on the Control/
Controller unit.
? No sound can be heard, or the volume is low.
✔ The input/output wires or wiring harness are
connected incorrectly.
☞ Reconnect the input/output wires and/or the
wiring harness correctly. See the section on
<Connecting Wires to Terminals>.
✔ The preset broadcast station is not transmitting in
the mode that was set with <Receive Mode>.
☞ Please set <Receive Mode> to "Auto".
✔ It switches between the Digital broadcasting and
Analog broadcasting too often.
☞ If the receiving condition is bad, <Receive
Mode> should be set to "Analog".
✔ In digital AM broadcasting, receive mode switches
between stereo and monaural too often.
☞ Receiving condition is bad or unstable.
Stereo is chosen when receiving condition is
good, and it switches to monaural when the
condition becomes bad.
✔ The source mode was changed or the power
switch was turned on.
☞ The monaural signals are received several
seconds after power-on or after FM tuning of
HD Radio.
✔ HD Radio tuner is connected to KCA-S210A or
other units.
☞ Connect the HD Radio tuner directly to the
control unit.
? Radio reception is poor.
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
✔ The antenna control wire is not connected.
☞ Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>.
? The tuner cannot be used by the Dual Zone
System.
✔ The HD Radio source cannot be selected by the
Dual Zone System.
☞ An internal source other than Tuner can be
selected.
The messages shown below display your
systems condition.
Linking: Although the Sub channel was selected, it
is under reading or has not been received.
➪ ––
HD* Off:/ *CH Off:
The Sub channel, which cannot be used,
was selected.
➪ ––
<Receive Mode> is set to "Analog";
therefore, the channel cannot be used.
➪ Set <Receive Mode > (page 7) to "Auto"
or "Digital".
• In HD Radio mode, the display of Station Name or
Song title should be set up. The channel information
cannot be displayed in the Frequency display. (page
8)