Filter
Top Products
8
|
English
General features
4 Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item Display Range
Bass Center Frequency "BasF" 40/50/60/70/80/100/
120/150 Hz
Bass Q Factor "BasQ" 1.00/1.25/1.50/2.00
Bass Extend "B EX" ON/OFF
Middle level
Adjustment Item Display Range
Middle Center Frequency "MidF" 0.5/1.0/1.5/2.0 kHz
Middle Q Factor "MidQ" 1.0/2.0
Treble level
Adjustment Item Display Range
Treble Center Frequency "TreF" 10.0/12.5/15.0/17.5 kHz
5 Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
⁄
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL] and [ATT] buttons.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass Filter "HPF" Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter "HPR" Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter "LPF" 50/60/80/100/120/Through Hz
Subwoofer Phase "PHAS" Normal (0°)/ Reverse (180°)
Volume offset "V-OFF" –8 — ±0 (AUX: -8— +8)
Loudness "LOUD" ON/OFF
Dual Zone System "2ZON" ON/OFF
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones
during low volume. (Only the low tone is
compensated for when the tuner is selected
as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 23).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 7).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the internal
auxiliary input.
5 Exit Audio Setup mode
Press any button.
Press a button other than the [VOL] knob, [SRC],
[0] and [ATT] button.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.