Filter
Top Products
English
|
23
In Standby mode
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the ACC is
set to OFF, warning potential thieves.
Display Setting
"S.I ON" LED flashes.
"S.I OFF" LED OFF.
Other than Standby mode/
When the Dual Zone System is ON
Dual Zone System Setting
Setting the Front channel and Rear channel sound
in the Dual Zone System.
Display Setting
"ZONE2 R" Sub source (Auxiliary input source) is to be rear
channel.
"ZONE2 F" Sub source (Auxiliary input source) is to be front
channel.
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external amplifier
using the main unit.
Display Setting
"BMS FLT" Bass boost level is flat.
"BMS +6" Bass boost level is low (+6dB).
"BMS +12" Bass boost level is mid (+12dB).
"BMS +18" Bass boost level is high (+18dB).
⁄
• Refer to the catalog or instruction manual for power
amplifiers that can be controlled from this unit.
• For amplifiers, there are the models you can set from Flat
to +18 dB, and the models you can set from Flat to +12
dB.
When an amplifier that can only be set to +12 is
connected to the unit, "BMS +18" will not work correctly
even if it is selected.
Other than Standby mode
B.M.S. Frequency Offset
Setting the central frequency, boosted by B.M.S.
Display Setting
"BMSF NML" Boost with the normal central frequency.
"BMSF Low" Drop the normal central frequency 20%.
In FM reception
CRSC (Clean Reception System Circuit)
Temporarily have reception alternate from stereo to
mono to reduce multi-path noise when listening to
the FM station.
Display Setting
"CRSC On" The CRSC is ON.
"CRSC Off" The CRSC is OFF.
⁄
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned ON.
In such a situation, turn it OFF.