Filter
Top Products
16
Setup of the Graphical Remote Control (GRC) unit
7 Press the “Code” icon. You can now choose from a list of
all the codes available for the device. Select the first code
on the list.
÷ When a code which is not shown in the setup code chart is entered,
the entered code disappears automatically.
÷ Even when the system control code is connected, some models may
not automatically display the “System” screen.
÷ With CD-Carrousel, select “Sys-carrousel”.
÷ When CD, MD and TAPE are connected through system control
cords, select “System”.
8 Press the “Check” icon.
2 Press the “Modify” icon.
Check the operation of the component.
1 Display the operation screen of the component to be checked.
2 Turn on the component from the GRC and confirm the actual
component.
÷ If there is more than one setup code, select the “Check” icon.
This instructs GRC to send a “Power” test signal to the receiver.
If your device turns on, the code you entered was correct. If it
does not turn on, try the next code in the list. Continue until one
of the codes works.
Although each setup code is designed to work with a
number of different models, certain codes may not work
with some models. (Also, certain codes may only oper-
ate some of the functions available on a given model.)
With some models, be sure to keep the Check icon
pressed for a while.
Note
Note
3 Select the function to be programmed.
9 Press the “Enter” icon.
÷ If the device power cannot be turned ON/OFF, return to 7 and select
the net code in the list.
Repeat 7 and 8 until the device power can be turned ON and OFF
properly.
Programming remote control functions
To program STOP as a new control item
1 Perform steps 1 to 4 in 1.
4 Aim the device’s remote at GRC and press and hold the
button on the device’s remote that corresponds to the
command you want GRC to learn.
10 cm
Continued to next page
Set up other components in the same way as above.
Remote control functions of some components may not be available even after the setup codes have been registered. In this
case, required functions can be programmed as if the GRC unit “learns” them.
÷ This may take a few seconds; do not move GRC or the device’s remote
until GRC displays the the Function change menu again.
÷ Be sure to use the device’s original remote. GRC will not learn
commmands from other universal remotes.