Filter
Top Products
15
Pause / stop
To briefly pause playback, press the “ PLAY
/ PAUSE” button (13)/(38). Display indicates:
Press “ PLAY / PAUSE” button again to
restart play.
To end the playback, press the “STOP” button
(11)/(45).
4. Press the “ TUNING + or TUNING -”
button (18) or (20) to select desired track.
5. Press the “PLAY/PAUSE” button to play MP3.
Playback in random sequence
Press the “RANDOM” button (35) on the remote
control in stop condition to start random play.
By pressing button “STOP” (11)/(45), the
random playback is cancelled. This function can be
switched off by pressing “RANDOM” button again.
Repeat
Press the “REPEAT” button (12)/(47) during MP3
playback to have the title currently being played at
repeated continuously.
Press the “REPEAT” button again to have the
entire MP3 disc played continuously.
Press the “REPEAT” button again to have all the
inserted MP3 discs played continuously.
Title introduction
Press the “INTRO” button (34) during stop mode to
playback the first 10 seconds of each title.
Press the “INTRO” push-button again and the CD
player plays the current selected track.
Program memory
The built-in program memory enables up to 40 titles
to be played from up to 4 CDs in the order of your
choice. Any title can be stored more than once
within one program.
Insert a CD in its compartment.
By pressing the button “MEM./CLK ADJ.” (9)/
(50) in the stop mode you can switch to
programming mode.
1.
2.
16
Press the “MEM./CLK ADJ.” (9)/(50) to save
the title on the first program location. In display
unit (3) appears:
4.
Confirm selection using the “MEM./CLK ADJ.”
button (9)/(50).
To store the remaining titles in the memory,
repeat steps 3 - 5.
5.
6.
To play back the program, press the “PLAY
/ PAUSE” button (13)/(38). When “PLAY /
PAUSE” is pressed, the program can be played
back again as long as MEMORY appears on the
display unit (3).
To clear the programming (Resume Normal
Playback):
The programming is erased by pressing the “
STOP” button (11)/(45) in the programming mode
(until the MEMORY display disappears), or by
opening the disc compartment.
CARE AND MAINTENANCE
Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact with the
shiny, unprinted side of the disc.
Do not attach adhesive tape, stickers etc., to the disc label.
Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to
clean the disc. If necessary, use a CD cleaning kit.
If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc. Never
wipe in circular motions.
To remove a disc from its storage case, press down on the centre of the case and lift the disc outs,
holding it carefully by the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth. Unlike
conventional records. compact disc have no groove to collect dust and microscopic debris, so gently
wiping with a soft cloth should remove most particles.
Note:
REPEAT button (12)/(47) is not used for
programming.
Select the desired title using the numeric
buttons “0 - 9 / +10” (33) on the remote control
device or by repeatedly pressing “
TUNING + or TUNING - ”.
3.
ID3 TAG (Artist/Title)
When an MP3 disc is playing, press the “MP3
MODE” button repeatedly. The track no., title and
artist information will be shown in the display if disc
information is available.
To resume normal play display, press the “MP3
MODE” button repeatedly until playing time
reappears.