Filter
Top Products
– 28 –
English
To stop during play, press 7.
To fast-wind to the left or to the right, press 4 or ¢.
To remove the cassette, press TAPE EJECT 0.
To play both sides — Reverse Mode
You can set the deck to play just one side of a tape, both
sides once, or both sides continuously.
On the remote control ONLY:
Press REV. MODE.
• Each time you press the button, the reverse mode
changes as follows:
: To only play back one side (front or reverse).
: To play back the front and reverse sides once.
: To play back both front and reverse sides
continuously.
To check the clock time while playing back a tape
On the remote control ONLY:
Press DISPLAY/CHARA.
• Each time you press the button, the source indications
and the clock time alternate on the display.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the
pinchrollers and the capstans.
Playing Back a Tape
You can play back type I, II, and IV tapes.
1
Press TAPE EJECT 0.
The cassette holder opens.
2
Put a cassette in with the exposed part of the tape in
front.
3
Close the cassette holder gently.
4
Press TAPE 2 3 .
The unit automatically turns on and the tape play starts.
• Each time you press the button, the tape direction
changes as follows:
:plays the front side.
:plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
or . (See “To
play both sides — Reverse Mode” to the right.)
TAPE EJECT
A
TAPE EJECT
Cassette holder
Cassette holder
Tape direction
Reverse mode
Tape indicator
DO NOT press TAPE EJECT 0 during tape play.
EN22-28UX-F70MD[UB]_f 01.7.10, 3:00 PM28