Filter
Top Products
– 47 –
English
Troubleshooting
Symptom
No sound is heard.
Unable to record on an MD.
Poor radio reception.
Unable to operate the remote
control.
Loaded CD and MD can not be
ejected.
The CD does not play.
The CD skips.
Operations are disabled.
Possible Cause
Connections are incorrect or loose.
• You are using a prerecorded MD.
• The MD is write-protected.
• The antenna is not connected correctly.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
• The path between the remote control and the
remote sensor on the unit is blocked.
• The batteries have lost their charge.
• You are using the remote control far from
the main unit.
The main AC power cord is not plugged in.
The CD is upside down.
The CD is dirty or scratched.
The built-in microprocessor has malfunctioned
due to external electrical interference.
Action
Check all connections and make
corrections. (See pages 6 – 9.)
• Change it with a recordable MD.
• Unprotect the MD. (See page 26.)
• Reconnect the antenna securely.
• Change the position and direction
of the AM loop antenna.
• Extend FM antenna to the best
reception position.
• Remove the obstruction.
• Replace the batteries. (See page 9.)
• Signals cannot reach the remote
sensor. Move close to the main
unit.
Plug in the AC power plug.
Put the CD in with the label side up.
Clean or replace the CD. (See page
43.)
Unplug the unit then plug it back in.
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
EN43-48.UX-A70MD[USUBUJ]_f 00.12.4, 4:31 PM47