JVC TH-D51 Stereo System User Manual


 
29
Before operating external components from the remote
control, set the manufacturer’s code.
1 Set the remote control mode (see above).
2 Press and hold for the target component
until the setting is finished.
3
4 Enter the manufacturer’s code.
See “Manufacturer’s code list” for the
manufacturer’s code. ( 30)
5 Release .
If there is more than one code listed
for the corresponding brand, try each one until you
enter the correct one.
Set the codes after replacing batteries of the remote
control.
Set the remote control mode before operating each
external component (see the left column).
Operating the TV
Operating the STB
Operating the VCR
Setting the manufacturer’s code
For TV For STB For VCR
Set the remote control mode before
operation.
For TV
For STB
For VCR
Preparation
Make the audio/video input setting
before operation. ( 13)
«Hold
«Hold
Operating external components
TV
Turns the power on and off
TV VOL +/– Adjusts the volume
TV/VIDEO Selects the input mode (either
TV or VIDEO)
CH +/– Changes the channels
1-10, 0, h 10
(100+)
Selects the channels
TV RETURN Alternates between the
previously selected channel
and the current channel
VCR/STB
Turns the power on and off
CH +/– Changes the channels
1-10, 0, h 10
(100+)
Selects the channels
RETURN Alternates between the
previously selected channel
and the current channel
VCR/STB
Turns the power on and off
3 (play button) Starts playback
7 Stops playback
8 Pauses
y Fast-forwards the tape
1 Rewinds the tape
REC Press this button together with 3
(play button) to start recording or
together with 8 to enter recording-
pause.
CH +/– Changes the TV channels
0 - 9 Selects the TV channels
Operating external components
TH-D51[B]EN.book Page 29 Friday, August 3, 2007 10:26 AM