Filter
Top Products
12
Using the surround mode
Select one of the available surround
modes.
• During playback with “S.SPK F” speaker position
mode:
• When the speaker position mode is “S.SPK R”:
To check the surround mode currently selected, press
SURROUND once.
During playback of ASF, MPEG-2, or MPEG-1 files,
the surround mode setting is ineffective.
During playback of DivX, the surround mode setting
is effective only for multi-channel files with “S.SPK R”
selected as the speaker position mode.
For DVD Audio, when “LR ONLY” appears on the
display, activate the surround mode for the multi-
channel reproduction.
Setting the scanning mode
Select the scanning mode for the sources “DVD”
and “USB” according to the type of TV and to connection
method.
1 Select “DVD” or “USB” as the source.
(10)
2
3 Select an appropriate scanning mode, then
confirm the selection.
• When connecting the TV via the HDMI
MONITOR OUT terminal ( 7), select
“AUTO,” “1080I,” “720P,” or “576P.”
• When connecting the TV via the COMPONENT
jacks ( 8), select “576P.”
• When connecting the TV via the AV (scart)
connector ( 8), select “RGB” or “Y/C.”
You can get better picture quality in the following
orders:
– 1080I > 720P > 576P
– RGB >Y/C
If the HDMI MONITOR OUT terminal and the AV
(scart) connector are both connected to a TV or TVs,
you cannot change the scanning mode for the AV
(scart) connector.
When the scanning mode does not correspond to
that of the TV, the picture is not displayed normally.
The surround modes you can select depend on the
playback source and the selected speaker position
mode ( 11). For details on each surround
mode, see “Available surround modes”
(31).
AUTO SUR = MOVIE = WIDE/2CH =
SUPER W = OFF = (back to the beginning)
When the source is “FM” or “AM,” the surround
mode cannot be activated.
During 2-channel playback:
AUTO SUR = MOVIE = MUSIC = STADIUM
= ALL ST = OFF = (back to the beginning)
When the source is “FM” or “AM,” you can only
select “ALL ST.”
During multi-channel playback:
AUTO SUR = currently selected mode* = OFF
= (back to the beginning)
*
When “AUTO SUR” is selected, the System
automatically selects a proper multi-channel
surround mode, such as “DOLBY D (Dolby Digital)”
or “DTS (DTS Digital Surround).”
Monitor settings
RGB
Select for the TV accommodating the
interlaced RGB/composite video
signal.
Y/C
Select for the TV accommodating the
interlaced S-video signal.
1080I
To watch the picture in interlaced
scanning mode.
576P
To watch the picture in progressive
scanning mode.
720P
AUTO
The System automatically emits the
video signal to give you the best
picture quality on your TV.
«Hold
Select Confirm
TH-D51[B]EN.book Page 12 Friday, August 3, 2007 10:26 AM