Filter
Top Products
8
Make sure the antenna conductors do not touch any
other terminals, connecting cords or power cords.
Connect the TV to the appropriate video out jacks to view
the playback picture.
The picture quality order is as follows:
HDMI > Component video > S-video > Composite
video
Make the following settings after connecting the TV:
– Color system and scanning mode ( 15)
– MONITOR TYPE ( 26)
Connection using the HDMI terminal
You can make the following settings for the TV when
the HDMI connection is used:
– HDMI DVI COLOR ( 26)
– HDMI OUT ( 26)
– HDMI AUDIO OUT ( 26)
–DOWN MIX ( 26)*
Use a certified HDMI cable, which has the HDMI
logo.
You can use a monitor with a DVI terminal by
connecting with a DVI-HDMI conversion cable.
When you play HDCP (High-Bandwidth Digital
Content Protection) source, it takes a few seconds
for the sound and picture to be transmitted to the
speakers and TV while the confirmation process is
completed.
On some TVs, no sound may come out during
playback of sources such as DVD Audio even when
the HDMI AUDIO OUT setting is “ON” ( 26).
*
This setting is available only when the speaker position
mode is set to “S.SPK F” ( 13).
Connecting the AM and FM
antennas
For better FM reception
Extend it horizontally.
FM antenna
(supplied)
AM loop antenna
(supplied)
Turn it until the best
reception is obtained.
FM outdoor antenna
(not supplied)
Standard type (75 Ω
coaxial) connector
FM outdoor antenna cord
(not supplied)
Connecting a TV
TV
From HDMI input
terminal
HDMI cable (not supplied)
Continued on the next page
Do not connect the power cord
until all other connections have
been made.
TH-D7D5[U]EN.book Page 8 Wednesday, June 13, 2007 10:19 AM