Filter
Top Products
20 TD-EX90
ACTION
• Use a different cassette
tape.
• If you don’t mind erasing
the previously recorded
material, cover the holes
with tape.
• Press ¤ or ‹ to release
the pause.
• Check to make sure the all
equipment is connected
correctly.
• Adjust the volume on the
amplifier.
• Set the source selector
(INPUT) to tape.
• Try a different cassette
tape.
• Clean the heads, capstans,
and pinch rollers.
• Demagnetize the heads.
• Clean the erase head.
• Set the Dolby NR to the
same setting used for
recording.
• Plug the AC power cord into
a wall outlet.
• Move cassette deck away
from amplifier/tuner.
• Unplug the power cord,
wait a few hours and plug it
again.
• Unplug the power cord then
plug it in again.
Troubleshooting
POSSIBLE CAUSE
• The tabs on the cassette
have been removed.
• The deck is set to pause.
• Connections are incorrect or
incomplete.
• Volume control on amplifier
is turned all the way down.
• The source selector (INPUT)
on the amplifier is set to a
different source.
• The blank spaces between
songs is too short.
• The heads, capstans, and
pinch rollers are dirty.
• The play and record heads
have become magnetically
charged.
• The erase head is dirty.
• The Dolby NR setting is
different from that used for
recording.
• The AC power cord is
unplugged.
• Cassette deck is directly
above or below the
amplifier/tuner.
• Condensation is produced
inside the cassete deck
immediately after starting
the room heating or when it
is transported from a cold to
warm place.
• The microcomputer is
malfunctioning due to
external noise or lightning.
If you experience any difficulty with your cassette deck, check the following list for a possible
solution before calling for service.
If you cannot solve the problem from the hints given here, or the cassette deck has been physically
damaged, call a qualified person, such as your dealer, for service.
SYMPTOM
Recording is not possible
No sound
Music scan does not work
Sound level is low or sound is
intermittent
Tape hiss or absence of high
frequency sounds
Previously recorded material is
not erased when recorded over
Bad sound quality or absence
of high frequency sounds
Cassette holder will not open
(or close)
Humming noise
Operation is abnormal.
1-23.TD-EX90[J]/1 5/12 98.6.4, 11:59 AM20